microgiant.
RRCRat Rig Community [Unofficial]
•Created by microgiant. on 3/20/2025 in #fix-my-printer
Status LEDs not changing color
I think I have solved this. The macros are not active until you copy them to your printer.cfg. Is that correct?
4 replies
RRCRat Rig Community [Unofficial]
•Created by 8Complex on 3/16/2025 in #ratos-support
LED Status Actions
They are called from the macros that are relavent to the status color. for example in macros.cfg under [gcode_macro START_PRINT] there is an entry of # visual feedback
_LED_START_PRINTING.
6 replies
RRCRat Rig Community [Unofficial]
•Created by mystic_macaroni on 2/3/2025 in #fix-my-printer
Vcore4 500 IDEX: Layer Shifts & Y Belt Tensioning
Do you have your machine in performance mode? If not that is the likely cause.
7 replies
RRCRat Rig Community [Unofficial]
•Created by mystic_macaroni on 2/3/2025 in #fix-my-printer
Vcore4 500 IDEX: Layer Shifts & Y Belt Tensioning
Oh sorry, Im still running Hybrid so these graphs are not helping.
7 replies
RRCRat Rig Community [Unofficial]
•Created by mystic_macaroni on 2/3/2025 in #fix-my-printer
Vcore4 500 IDEX: Layer Shifts & Y Belt Tensioning
These are mine but this mostly affects VFAs
7 replies
RRCRat Rig Community [Unofficial]
•Created by mystic_macaroni on 2/3/2025 in #fix-my-printer
Vcore4 500 IDEX: Layer Shifts & Y Belt Tensioning

7 replies
RRCRat Rig Community [Unofficial]
•Created by mystic_macaroni on 2/3/2025 in #fix-my-printer
Vcore4 500 IDEX: Layer Shifts & Y Belt Tensioning
Did you fix this? I think my machine is hitting curled up overhangs catching and skipping. I just finished building it and my first few multiday prints have ended in disaster. Other possible problems are overextrusion (do a flow rate calibration), Belt tension incorrect, too fast acceleration speeds in slicer
7 replies
RRCRat Rig Community [Unofficial]
•Created by microgiant. on 2/19/2025 in #fix-my-mesh
Leveling a warped Bed Mesh Vcore4 500mm
I see, well I am envious of that guy who has a .12 bed. Im going to move on to the next step but if anyone wants to chime in about how they achieved an even flatter mesh please do.
8 replies
RRCRat Rig Community [Unofficial]
•Created by microgiant. on 2/19/2025 in #fix-my-mesh
Leveling a warped Bed Mesh Vcore4 500mm

8 replies
RRCRat Rig Community [Unofficial]
•Created by microgiant. on 2/19/2025 in #fix-my-mesh
Leveling a warped Bed Mesh Vcore4 500mm
Great! I made some changes that made it better but Im not sure what I did to the two rails that go from the front to the rear. Correct me if I am wrong but if I move both of them up or down the same amount wont it be compensated for in Z-tilt?
8 replies
RRCRat Rig Community [Unofficial]
•Created by DarylDee on 2/1/2025 in #fix-my-mesh
2 level mesh V-Core 4 - 400 - IDEX
I wish I had his problems 💯
7 replies