Navdeep Kaushal
RRCRat Rig Community [Unofficial]
•Created by Navdeep Kaushal on 2/28/2024 in #fix-my-printer
BLtouch Z_offset
So I installed Biqu H2 V2s lite extruder/hotend on my VC 3.1. Updated X and Y offset under Bltouch section and it started showing error and asked to uncomment Z offset as well
Now everytime I update my z offset and save config it gets automatically commented out and printer shows the same error. Neither does that update the z offset. Please help
I'm attaching my printer.cfg file
21 replies
RRCRat Rig Community [Unofficial]
•Created by Navdeep Kaushal on 7/23/2023 in #fix-my-printer
Board detected but unresponsive
3 replies
RRCRat Rig Community [Unofficial]
•Created by Navdeep Kaushal on 7/11/2023 in #ratos-support
Installed RatOS but can't flash the Octopus
36 replies