jpvonoy
RRCRat Rig Community [Unofficial]
•Created by jpvonoy on 5/13/2024 in #ratos-support
Settings locations and priorities / hierarchy / overrides?
Thanks, that's very helpful. When talking about RatOS, the UI has many settings that can be adjusted during the print. Many of them clearly override the slicer settings, e.g. temperatures, speeds. Is this true for all settings, like PA, and retraction? What if I set those values in the UI prior to starting a print? Will they still override the slicer settings, or do they take on the slicer values at the start of a new print? The speed multiplier seems to persist it's override between prints.
7 replies
RRCRat Rig Community [Unofficial]
•Created by jpvonoy on 5/19/2023 in #ratos-support
Rpi touchscreen blank with backlight on after bootup
Thank you. And thank you for all your work on this project, I've been really enjoying this printer!
14 replies
RRCRat Rig Community [Unofficial]
•Created by jpvonoy on 5/19/2023 in #ratos-support
Rpi touchscreen blank with backlight on after bootup
Great information, just what I was about to ask. I appreciate your assistance. I remember it took me weeks to figure this all out and get everything setup properly when I built the machine. I was dreading attempting that again.
14 replies
RRCRat Rig Community [Unofficial]
•Created by jpvonoy on 5/19/2023 in #ratos-support
Rpi touchscreen blank with backlight on after bootup
I just looked at the versions. The RatOS version that isn't displaying properly is shown as "v1.2.4-4-g898b8ae" in the Update Manager. Under System Loads, it shows "Distro: RatOS 1.2.2 (buster)". The fresh install that works has "2023-04-11-RatOS-v2.0.1-raspberry-rpi32.img.xz"
14 replies