jpvonoy
RRCRat Rig Community [Unofficial]
•Created by jpvonoy on 5/13/2024 in #ratos-support
Settings locations and priorities / hierarchy / overrides?
I have a RatRig V-Core 3 running RatOS on a raspberry pi and I use superslicer. Is there a diagram or chart that lists all the places that settings can be adjusted along with which ones override which. This includes the settings in superslicer and printer.cfg as well as all the other config/macro files. I am always wondering where I should make changes to various settings/configuration and questioning if they're being overridden somewhere else. One example, if I want to change PA for a new filament, and I change it in RatOS, does this override everything else? I think it's also set in my printer.cfg, my start G-Code in superslicer, maybe elsewhere too?
7 replies
RRCRat Rig Community [Unofficial]
•Created by jpvonoy on 5/19/2023 in #ratos-support
Rpi touchscreen blank with backlight on after bootup
I use an Rpi 4B with the official touchscreen. I restarted the Pi recently and after splash screen is displayed and it completes bootup it just has a blank screen with the backlight on. I am able to connect via WiFi from my laptop and use the printer like that with no issues. I loaded a fresh RatOS install on a new SD card and the display works normally. I don't want to go through the entire setup process again for a new install. Any ideas on how to troubleshoot or fix this?
14 replies