Kotaa
RRCRat Rig Community [Unofficial]
•Created by Kotaa on 2/19/2025 in #fix-my-printer
bed mesh and first layer issues
2 replies
RRCRat Rig Community [Unofficial]
•Created by Kotaa on 1/16/2025 in #fix-my-mesh
New vc4 500 idex
New here and having issues with a new vc4. I cannot seem to get a good mesh. First layer runs from being to squish in the front left to barely sticking in the back right. I have gone back over the gantry and even replaced it when it was suspected to have a twist. releveled and adjusted the frame as well. Is the bed just that bad? any suggestions?
2 replies