bed mesh and first layer issues

I have an vcore 4 idex 500. The bed mesh shows the bed as being warped. I have attempted multiple adjustments, checked and rechecked everything. attached are 2 screenshots of the bed mesh of the last print attempt and the default. Any help would be greatly appreciated.
No description
No description
2 Replies
War-El
War-El5w ago
What temperature is the mesh taken at? And enclosed or open? Could be the gantry warping by temp.
MDFPereira
MDFPereira5w ago
That is almost impossible to get that low right corner after z_tilt. At least not that bad. Also, mesh min and max can be causing it. Can you share debug.zip? Oh, nevermind! You are only getting 0.2 variation. On a 500 it is maybe the best I’ve seen. Just move your slider to the left if will look way better. Contact mesh is only for beacon calibration purposes. It is not used for anything else. What matters is the RatOs that is done before every print Even then, can you share ratos_debug.zip? Looks like either it is not doing z tilt or beacon is doing the mesh outside the plate

Did you find this page helpful?