jay777
RRCRat Rig Community [Unofficial]
•Created by jay777 on 6/11/2024 in #fix-my-printer
(RESOLVED) Beacon firmware not updating
I hit update all and started getting firmware out of date errors. Searching posts lead me to try and update using SSH with no luck. Tried the configurator and only found the control board and toolboard. I have not followed the beacon site instructions as I read that ratOS should already be setup. Enclosed is everything I can think of to include.
16 replies
RRCRat Rig Community [Unofficial]
•Created by jay777 on 3/31/2024 in #fix-my-printer
New Beacon setup. No clues...
I have an enclosed 500 with the toolhead 1.0 beta2 setup. I am using the toolhead from https://www.printables.com/model/720356-ratrig-toolhead-beta2-beacon-probe-revh-mount to mount the beacon Rev H. The issue that I have is that I don't see a standard setup for it. Can someone copy/paste that chunk here so I can see what they are using?
I ended up with this but am wanting to wait to run it as I don't want the hotend dug into the printbed.
####################################################################################################
Beacon Setup
####################################################################################################
[include RatOS/z-probe/beacon.cfg]
[beacon]
y_offset: 20.676
speed: 5
#[resonance_tester]
#accel_chip: beacon
#probe_points: 250, 250, 20
[stepper_z]
endstop_pin: probe:z_virtual_endstop # use beacon as virtual endstop
homing_retract_dist: 0 # beacon needs this to be set to 0
homing_speed: 5
[bed_mesh]
horizontal_move_z: 5
mesh_min: 35,30
mesh_max:465,470
probe_count: 25,25
fade_start: 1.0
fade_end: 10.0
mesh_pps: 2,2
algorithm: bicubic
bicubic_tension: .2
speed: 300
[z_tilt]
z_positions:
0,0
250,500
500,0
points: 60,60 250,470 460,60
horizontal_move_z: 20 retries: 10 retry_tolerance: 0.02 ####################################################################################################
points: 60,60 250,470 460,60
horizontal_move_z: 20 retries: 10 retry_tolerance: 0.02 ####################################################################################################
7 replies