JamieDownweeezy
RRCRat Rig Community [Unofficial]
•Created by JamieDownweeezy on 5/4/2024 in #ratos-support
pi 3b not booting
i have an old pi 3b that came with my v minion but im just getting a solid red led no other lights when powering up, any ideas what it is? bricked pi?
3 replies
RRCRat Rig Community [Unofficial]
•Created by JamieDownweeezy on 4/27/2024 in #ratos-support
Flashing RATOS to Raspberry pad 5 with CM4
Anyone did this already? I've tried following the manual but just getting a blank screen, tried inserting an sd with the RATOS image with no joy and just getting lost trying to flash the emmc, I have a 2gb ram 8bg cm4 with no wireless, out of my depth flashing emmc via rpiboot
9 replies
RRCRat Rig Community [Unofficial]
•Created by JamieDownweeezy on 4/27/2024 in #fix-my-printer
Raspberry pad 5 - black screen CM4
I've tried following the instructions as best as possible to replace my Pi3b with a cm4 in a raspberry pad 5 I bought a year ago with a BTT CB1 8 didn't realise wouldn't work with a pi image at the time.
I've tried flashing the Sd card with the Rat OS image, but the screen is just black.
I accidentally bought the non WiFi CM4 and not sure if I need to connect the raspberry pad to my router via network cable to access the pi to make changes to get the screen on, any help would be massively appreciated #help #cm4 #rapberrypad5
3 replies
RRCRat Rig Community [Unofficial]
•Created by JamieDownweeezy on 3/23/2024 in #fix-my-printer
Raspberry PI3b red light only
Just had to flash my mcu, not used my printer in a while and since I've built my control box back up my pi has a steady red light. Can't find my printer now on the network.
I'm sure it should be flashing green when reading the sd card
Have i damaged the pi? #pi3b #vminion
2 replies
RRCRat Rig Community [Unofficial]
•Created by JamieDownweeezy on 1/17/2024 in #fix-my-printer
Bond tech LGX Lite clicking
having issues with my bondetch lgx lite clicking and hotend clogging since upgrading to EVA3, tried cleaning hot end cleaning gears of extruder, seems to load filament but then filament gets thinner and thinner out of nozzle before starting to click then nothing will get through. any suggestions? on a v minion if that helps no issues until ive sapped to eva3.
4 replies
RRCRat Rig Community [Unofficial]
•Created by JamieDownweeezy on 12/10/2023 in #fix-my-printer
Extruder error on V minion
recently rewired my V minion and shortened all the cables with the SB modded untethered case but since then when the extruder tries to kick in i get this error, any ideas?
TMC 'extruder' reports error: DRV_STATUS: 001600d0 s2vsa=1(ShortToSupply_A!) ola=1(OpenLoad_A!) olb=1(OpenLoad_B!) cs_actual=22
3 replies