bguthrie96
bguthrie96
RRCRat Rig Community [Unofficial]
Created by bguthrie96 on 11/10/2024 in #fix-my-printer
IDEX TOOLHEAD OFFSET - way out of specification
I have been working through many issues with the IDEX system but this one I just can't seem to get through. The X value for the IDEX offset is @ -8.75 when it should be under 1.2 per the commissioning guide. Both toolheads go to exact x locations above build plate @ -15 and 515 respectfully, VAOC dials in pretty good and returns after exiting and returning so that is all working, the z offset is a little out because I haven't hot tightened T1 yet (in fact haven't even pushed plastic through it yet). I have attached the ratos-debug file for you guys to look at when you get a chance and maybe push me in the right direction.
3 replies
RRCRat Rig Community [Unofficial]
Created by bguthrie96 on 10/27/2024 in #fix-my-printer
VAOC not working - camera not connecting
New assembly upgraded from working vcore 4 hybrid to idex. Had to reconfigure from start due to MCU board issue with merging. All went well until camera does not connect in VAOC tab or webcam window on dashboard. Attached ratos-debug.zip to try and help.
6 replies
RRCRat Rig Community [Unofficial]
Created by bguthrie96 on 10/19/2024 in #fix-my-printer
VCORE 4 MCU LOST COMMUNICATION
Brand new 500 build. Everything went very well, flashed no issues, booted up no issues, did initial calibrate per Commissioning instructions, about 30-40 seconds in to the zeroing the unit stops and sends a klipper shutdown because lost communication with MCU. What have I done - changed out cables to see if it followed cable, verified all connections are inserted properly and not loose in any way, powered the pi with an outside power supply so current is not an issue, updated all codes through mainsail so everything up to date. Looking for some insight on what to dive in to next??? Octopus V1.1, PI 4b, EBB42
4 replies