ItsJesus
RRCRat Rig Community [Unofficial]
•Created by ItsJesus on 6/6/2024 in #ratos-support
Is it possible to edit board-definition.json (SKR 3 pin definition error)
15 replies
RRCRat Rig Community [Unofficial]
•Created by ItsJesus on 3/5/2024 in #ratos-support
remote access/port forwarding
This is more of a general networking question, but I am not familiar with port forwarding, and I would like to get to a point where I can remotely access ratos without having a computer on the same network (printer is in a warehouse, and I can access ratos remotely) I have gotten around this by putting a computer at the warehouse, but ideally I would like to be able to get rid of the computer and do everything remotely.
Is this possible by port forwarding the IP address the raspberry pi is connected to, and connecting to moonraker using a public ip/port?
4 replies
RRCRat Rig Community [Unofficial]
•Created by ItsJesus on 9/11/2023 in #fix-my-printer
Delta 4 pin fan not working
I have been attempting to get my Delta FFB0412UHN-SM36 supplied by ratrig to work. I have extended the fan following the pinout for my board (SKRat V1.0) and the fan does not spin. When I remove the PWM wire, or change its location, the fan spins up to 100% with no control. I have verified my connections between the fan, the extension, the extension and the board side JST plug, and everything has continuity. Any ideas?
6 replies
RRCRat Rig Community [Unofficial]
•Created by ItsJesus on 9/8/2023 in #fix-my-printer
Various homing related issues
Currently having issues with the 5v inductive probe during bed leveling
25 replies