762x39 Comments - Answer Overflow

762x39

•Created by 762x39 on 3/7/2024 in #fix-my-printer

Want to change X&Y from motor outputs 1&2 to 4&5

Finally got around to do some tinkering. No errors until I try to home. Then I get this: TMC 'stepper_y' reports error: DRV_STATUS: 00130050 s2vsa=1(ShortToSupply_A!) ola=1(OpenLoad_A!) cs_actual=19

14 replies

RRCRat Rig Community [Unofficial]

•Created by 762x39 on 3/7/2024 in #fix-my-printer

Want to change X&Y from motor outputs 1&2 to 4&5

Ok, I wasn't sure if that was already covered in the include being as Z is working. So add this?: Motor4 #[tmc2209 stepper_X] #uart_pin: PD4 ##diag_pin: PC0 #run_current: 0.800 #stealthchop_threshold: 999999 Motor5 #[tmc2209 srepper_Y] #uart_pin: PD0 #run_current: 0.800 #stealthchop_threshold: 999999

14 replies

RRCRat Rig Community [Unofficial]

•Created by 762x39 on 3/7/2024 in #fix-my-printer

Want to change X&Y from motor outputs 1&2 to 4&5

I did set the jumpers, I'll verify when I get home from work tonight. It's possible that the drivers were damaged along with the motor ports. I need to know that l have it configured correctly to make that determination.

14 replies

RRCRat Rig Community [Unofficial]

•Created by 762x39 on 3/7/2024 in #fix-my-printer

Want to change X&Y from motor outputs 1&2 to 4&5

Unable to read tmc uart 'stepper_x' register IFCNT BTW: Z seems to be OK which leads me to believe the entire board isn't toast.

14 replies

RRCRat Rig Community [Unofficial]

•Created by 762x39 on 3/7/2024 in #fix-my-printer

Want to change X&Y from motor outputs 1&2 to 4&5

Hope that works, I rarely do attachments on Discord.

14 replies

RRCRat Rig Community [Unofficial]