Yveske
Explore posts from serversRRCRat Rig Community [Unofficial]
•Created by Yveske on 12/17/2024 in #fix-my-printer
VCore 4 500 IDEX Toolheads move when moving gantry in Y
Ok, my bad. The motor for the second toolhead got mixed up with the right Y motor in the setup.
13 replies
RRCRat Rig Community [Unofficial]
•Created by Yveske on 12/17/2024 in #fix-my-printer
VCore 4 500 IDEX Homing shakes the printer violently
Ok, my bad. The motor for the second toolhead got mixed up with the right Y motor in the setup.
4 replies
RRCRat Rig Community [Unofficial]
•Created by Yveske on 12/17/2024 in #fix-my-printer
VCore 4 500 IDEX Toolheads move when moving gantry in Y
All motors move in the correct direction.
13 replies
RRCRat Rig Community [Unofficial]
•Created by Yveske on 12/17/2024 in #fix-my-printer
VCore 4 500 IDEX Toolheads move when moving gantry in Y
It also moves in X when jogging in Y
13 replies
RRCRat Rig Community [Unofficial]
•Created by Yveske on 12/17/2024 in #fix-my-printer
VCore 4 500 IDEX Toolheads move when moving gantry in Y
I do have a problem with homing also, which I will post shortly in a separate post.
13 replies
RRCRat Rig Community [Unofficial]
•Created by Yveske on 12/17/2024 in #fix-my-printer
VCore 4 500 IDEX Toolheads move when moving gantry in Y
They are attached. Do I have to tension them more ?
13 replies
RRCRat Rig Community [Unofficial]
•Created by Yveske on 11/20/2024 in #ratos-support
RatOS installation: Flashing Octopus V1.1 via DFU - DFU not detected
My bad 🫣
10 replies