Yveske
Explore posts from serversRRCRat Rig Community [Unofficial]
•Created by Yveske on 12/17/2024 in #fix-my-printer
VCore 4 500 IDEX Homing shakes the printer violently
The end stop works (see clip 1), but when in the home position the printer starts to shake violently (see clip 2).
4 replies
RRCRat Rig Community [Unofficial]
•Created by Yveske on 12/17/2024 in #fix-my-printer
VCore 4 500 IDEX Toolheads move when moving gantry in Y
My X-belts are tight at 16.9 mm, my Y-belts are slightly more loose at 15.9 mm.
Measured at approx. 10 cm from the front with the heads and gantry approx. in the middle.
13 replies
RRCRat Rig Community [Unofficial]
•Created by Yveske on 11/20/2024 in #ratos-support
RatOS installation: Flashing Octopus V1.1 via DFU - DFU not detected
10 replies
