zybidk
RRCRat Rig Community [Unofficial]
•Created by zybidk on 7/6/2023 in #fix-my-printer
rpi don’t start on the same time
@Ryan.Tech No i don’t. First I have Think problem was ratos 2.0, but now I have ratos2.1 and problem are still so i turning on first rpi, waiting 5s and turning on printer. I power my rpi with power supplie
11 replies
RRCRat Rig Community [Unofficial]
•Created by zybidk on 10/24/2023 in #fix-my-print
holes in print
Thanks for tip. I have found problem. PA was ok top and bottom layer was ok just in corner was not ok. Problem was Line widht, was 0,62 and i have changed to 0,6 and problem are gone.
3 replies
RRCRat Rig Community [Unofficial]
•Created by zybidk on 7/6/2023 in #fix-my-printer
rpi don’t start on the same time
I have connected monitor to rpi. And nothing happend. Monitor are black and nothing changes. When i take off one usb kabel (skrat) then all start without problem. I make new instalation and flash one more time board and ebb42
11 replies
RRCRat Rig Community [Unofficial]
•Created by zybidk on 7/6/2023 in #fix-my-printer
rpi don’t start on the same time
11 replies
RRCRat Rig Community [Unofficial]
•Created by zybidk on 7/6/2023 in #fix-my-printer
rpi don’t start on the same time
When i take usb cabel and turnon all. Then pi boot normal. I don’t have ekstra monitor. All go from computer ratos.local. How can i change to SD?
11 replies
RRCRat Rig Community [Unofficial]
•Created by zybidk on 7/6/2023 in #fix-my-printer
rpi don’t start on the same time
I have Powered rpi from dc/dc converter direct from power supply. Skrat have jumper but i have take out all not needed jumpers. I have changed cabel rpi<->skrat 3x and it’s the same.
11 replies