Cigaroid
RRCRat Rig Community [Unofficial]
•Created by Cigaroid on 3/21/2025 in #ratos-support
Print pausing after tool change (waiting for temperature)
I am able to set a standby temperature in the ratos config of the vcore 4 idex, but is there no way to make the toolhead preheat the nozzle before it needs to be used? I always have to wait 15-30sec before the printer is ready to print again.
If I use the "ooze prevention" function in orca slicer the toolhead is correctly preheated, but I still have to wait till the not used toolhead to reach the standby temperature.
I imagine it would be a quite easy implementation in ratos to set variable preheat parameter.
If anyone got a soluton for that I would be very thankful 🙂
2 replies
RRCRat Rig Community [Unofficial]
•Created by Cigaroid on 3/20/2025 in #fix-my-print
Preheat Toolhead before Toolchange
I am able to set a standby temperature in the ratos config of the vcore 4 idex, but is there no way to make the toolhead preheat the nozzle before it needs to be used? I always have to wait 15-30sec before the printer is ready to print again.
If I use the "ooze prevention" function in orca slicer the toolhead is correctly preheated, but I have to wait till the not used toolhead to reach the standby temperature.
I imagine it would be a quite easy implementation in ratos to set variable preheat parameter.
If anyone got a soluton for that I would be very thankful 🙂
2 replies
RRCRat Rig Community [Unofficial]
•Created by Cigaroid on 3/8/2025 in #fix-my-printer
Cant turn on VAOC Led
Hi,
I wanted to calibrate my idex300 with the vaoc, but I'm not able to turn the LED on. I checked every cable and pin placement and measured the + / - pin with a multimeter on the connector of the led and it says 5V. In my printer config is no definition for the vaoc led (expect the macros). Is there anything missing or needed to be added? The camera itself is running fine.
Thanks for the help
3 replies