Qui1zy
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 11/23/2024 in #ratos-support
Provok 3D Nozzle ADXL
I was trying to set up my nozzle ADXL that I had just got, and I put it on my printer and tried to run the built in input shaper macro in RATOS 2.1.0 but i continued to get an error about an unknown probe. Does anyone know how to modify the macro / fix this error? The error was "Invalid adxl345 id (got ff vs e5)."
312 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 8/22/2024 in #ratos-support
Unable to install...
10 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 3/14/2024 in #ratos-support
Fan at 100%
Whenever I set the part cooling fan speed to 0% it for some reason is spinning at 100%, and whenever I set it to 100%, it turns off. Any ideas on how to fix this?
8 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 12/27/2023 in #fix-my-printer
I accidentally cracked a magnet.
11 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 12/26/2023 in #fix-my-printer
idk where the linear rail supposed to be…..
7 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 12/20/2023 in #fix-my-printer
my aluminum extrusion doesn’t match!
6 replies