Qui1zy
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 8/22/2024 in #ratos-support
Unable to install...
Ok. Thanks! I'll try it later this evening.
10 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 8/22/2024 in #ratos-support
Unable to install...
how do I do that?
10 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 8/22/2024 in #ratos-support
Unable to install...
it is the newest version of balena, and the file was a .img.xz
10 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 3/14/2024 in #ratos-support
Fan at 100%
tysm, it works
8 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 3/14/2024 in #ratos-support
Fan at 100%
where do I put that?
8 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 12/27/2023 in #fix-my-printer
I accidentally cracked a magnet.
Ok
11 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 12/27/2023 in #fix-my-printer
I accidentally cracked a magnet.
Because shipping from Ratrig will take a few weeks
11 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 12/27/2023 in #fix-my-printer
I accidentally cracked a magnet.
Or can I just leave it like this
11 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 12/27/2023 in #fix-my-printer
I accidentally cracked a magnet.
Do you think it would be fine if I just cover the magnet in a little@bit of superglue
11 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 12/27/2023 in #fix-my-printer
I accidentally cracked a magnet.
I can’t find a replacement
11 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 12/26/2023 in #fix-my-printer
idk where the linear rail supposed to be…..
Ok Thanks
7 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 12/20/2023 in #fix-my-printer
my aluminum extrusion doesn’t match!
I fixed it! It turns out I accidentally put a 705mm piece where a 710mm was supposed to go.
6 replies
RRCRat Rig Community [Unofficial]
•Created by Qui1zy on 12/20/2023 in #fix-my-printer
my aluminum extrusion doesn’t match!
Will do! It probably is sloppy frame building, it’s my first time building my own printer.
6 replies