dunkeluk
RRCRat Rig Community [Unofficial]
•Created by kilou77 on 3/11/2024 in #fix-my-print
Under extrusion at regular intervals
Glad you figured it out
7 replies
RRCRat Rig Community [Unofficial]
•Created by kilou77 on 3/11/2024 in #fix-my-print
Under extrusion at regular intervals
Good thinking! I will check mine as it does seem like there is much more pressure needed than there should be
7 replies
RRCRat Rig Community [Unofficial]
•Created by dunkeluk on 3/11/2024 in #fix-my-print
Layer inconsistency
Turned out to be I just needed to crank the screw down on my orbiter. I had already tightened it really hard with the thumb screw but there is a hex head too so gave that a couple turns and it fixed it
4 replies
RRCRat Rig Community [Unofficial]
•Created by kilou77 on 3/11/2024 in #fix-my-print
Under extrusion at regular intervals
I was having this yesterday but more dramatic (https://discordapp.com/channels/582187371529764864/1216712065943867392) - couldn't figure it out for ages but realised it was synced at once per rotation of the the extruder. Turned out to be I just needed to crank the screw down on my orbiter. I had already tightened it really hard with the thumb screw but there is a hex head too so gave that a couple turns and it fixed it so could be worth a try
7 replies
RRCRat Rig Community [Unofficial]
•Created by dunkeluk on 3/9/2024 in #fix-my-print
Terrible Extrusion Inconsistency On New V-core Build
Yeah makes sense - thanks! 🙏🏻
11 replies
RRCRat Rig Community [Unofficial]
•Created by dunkeluk on 3/9/2024 in #fix-my-print
Terrible Extrusion Inconsistency On New V-core Build
Think it's all good now
11 replies
RRCRat Rig Community [Unofficial]
•Created by dunkeluk on 3/9/2024 in #fix-my-print
Terrible Extrusion Inconsistency On New V-core Build
This washer was on the wrong side of the extruder gear arm (it's fixed in the image) , so there was always 1mm+ of gap, preventing any pressure on the filament 🤦🏻♂️
11 replies
RRCRat Rig Community [Unofficial]
•Created by dunkeluk on 3/9/2024 in #fix-my-print
Terrible Extrusion Inconsistency On New V-core Build
11 replies
RRCRat Rig Community [Unofficial]
•Created by dunkeluk on 3/9/2024 in #fix-my-print
Terrible Extrusion Inconsistency On New V-core Build
In the end it looks like it was the most stupid problem
11 replies
RRCRat Rig Community [Unofficial]
•Created by dunkeluk on 3/9/2024 in #fix-my-print
Terrible Extrusion Inconsistency On New V-core Build
Thanks for your reply - I figured the same so I spent a few hours trying to remove all the different variables: Tried printing extremely slowly, removed the bowden completely, added a controller cooler so I could use the full power on the stepper drivers
11 replies