Matt
RRCRat Rig Community [Unofficial]
•Created by Skye on 1/26/2025 in #fix-my-print
Vc4 500 hybrid 0.6mm nozzle
is your filament sliding thorugh the tubes well? might want to try w/o a tube or a short one just to rule that out
87 replies
RRCRat Rig Community [Unofficial]
•Created by Skye on 1/26/2025 in #fix-my-print
Vc4 500 hybrid 0.6mm nozzle
the cab/upper parts looks decent once the min layer time kicked in and either slowed it down or ramped the fans up... also in filament settings->advanced I always set a max flow rate so the slicer doesn't try to push too much filament... start at 20mm3 and increase from there. .. also the temp tower is a fairly slow print, once you are printing faster you need to turn up the temp to suit the speed since the core of the filament takes longer to heat up ... this is where CHT nozzles help
87 replies
RRCRat Rig Community [Unofficial]
•Created by Teckgeek on 1/27/2025 in #fix-my-printer
Hybrid confusion
look up "stepper buzz" and buzz each motor to make sure the go in the correct/same direction and the correct motor moves
14 replies
RRCRat Rig Community [Unofficial]
•Created by Skye on 1/26/2025 in #fix-my-print
Vc4 500 hybrid 0.6mm nozzle
have you done flow rate test/ measured filament diameter? looks like some underextrusion in places also maybe needs some more fan since it is such a small model the layer times are too short and the heat will build up
87 replies