Arahn
RRCRat Rig Community [Unofficial]
•Created by Arahn on 3/4/2025 in #fix-my-print
Z-Offset wanders a bit a the beginning of each print
Might be heat soaking, Ill look into it
3 replies
RRCRat Rig Community [Unofficial]
•Created by Arahn on 2/18/2025 in #fix-my-printer
Sensor 'extruder' temperature 45496.282 not in range - Differences in Rapido 2 Hotends?
Hey!
I am very sorry it took me so long to get back to this topic.
I found that the issue was, that I needed to buy the Rapido PLUS 2 UHF Hotend.
The Regular, non plus version, does feature a 104NT thermistor.
So, even though the manual speaks of the Rapido Hotend 2 hotend, the PLUS is required - or, at least a double check it does in fact feature a pt1000 thermistor 🙂
5 replies