mazas
RRCRat Rig Community [Unofficial]
•Created by mazas on 9/13/2024 in #ratos-support
BEACON_INITIAL_CALIBRATION moves the head to incorrect place, crashing head
7 replies
RRCRat Rig Community [Unofficial]
•Created by mazas on 9/1/2024 in #ratos-support
version mismatch, seems like a truncation issue?
14 replies
RRCRat Rig Community [Unofficial]
•Created by mazas on 8/2/2024 in #fix-my-mesh
VC4 400 Both back corners dip
204 replies
RRCRat Rig Community [Unofficial]
•Created by mazas on 6/1/2024 in #ratos-support
sensorless homing tuning hits other end
How should I tune sensorless homing? Now if I set
SET_TMC_FIELD STEPPER=stepper_x FIELD=SGTHRS VALUE=255 and G28 X0, it will detect stall immeditely and then try to move the the mid point of X carriage, which it now thinks is 150/200/250 mm towards the other end of the rail, and might hit the y extrusions. My question is really that how do I stop the override of G28 that moves the head to the middle. Tried looking at "homing_override", but only found reference to that in config/Ratos/klippy/ratos_homing.py, which seems to get registered in ratos-common.sh. However, this started to get a bit convoluted, and might be I am missing something, so I thought to ask.16 replies
RRCRat Rig Community [Unofficial]
•Created by mazas on 3/19/2024 in #ratos-support
Cannot set custom pin mappings when upgrading to 2.0
I get the error "Alias z2_step_pin mapped to PE6 - can't alias to PF9" when I actually do try to use PF9 as the z2_step_pin. This worked ok with Ratos1.x, but seems 2.0 is not exactly the same.
25 replies