K1ear
RRCRat Rig Community [Unofficial]
•Created by K1ear on 2/18/2024 in #fix-my-resonance
Newbie at adxl resonance testing
What can i do to improve these graphs.
4 replies
RRCRat Rig Community [Unofficial]
•Created by K1ear on 2/17/2024 in #fix-my-printer
X and Y motor axis confused even after swapping wires on mainboard
Whenever I home the printer the x-axis homes correctly and when the y gantry hits the switch the led turns green but the gantry mashes itself into the switch.
16 replies
RRCRat Rig Community [Unofficial]
•Created by K1ear on 2/17/2024 in #fix-my-printer
Extruder at constant 158.9c reading
I'm guessing this is a dead thermistor but I'm just asking for where I can even get one or if there's a solution perhaps.
9 replies
RRCRat Rig Community [Unofficial]
•Created by K1ear on 2/11/2024 in #ratos-support
Octopus V1.1 detected but is unresponsive.
58 replies