stizler
RRCRat Rig Community [Unofficial]
•Created by stizler on 11/28/2024 in #fix-my-printer
TMC 'extruder' reports error: GSTAT: 00000001 reset=1(Reset)
I also have some other problem.
When i select a job in the klipper screen 50% of the time the systems are failing because of timing problem. Also all systems.
6 replies
RRCRat Rig Community [Unofficial]
•Created by stizler on 11/28/2024 in #fix-my-printer
TMC 'extruder' reports error: GSTAT: 00000001 reset=1(Reset)
Hi,
1: Yes I check the wires and all is secure and well. I changed wires and cable. I soldered the wires to the beacon. still happens.
2:: changed driver, update, re install from the ratos. checke dall is OK on the hardware side.
3: Also used several cables.
these errors are accuring random on : 2x vcore 4 500 2x vcore 3.1 400 , vcore 3.1 idex 500
Machines are whit pi and cb1 octopus and a mante M8P hardware and on all systems this is happening.??
I truly believe that this is something software or firmware.
I'm running the printer day and night but at this moment I am verry negative about the unts because they are just not working whit this rendom BS.
I dont see a solution for this ? do you whant some debug files to check? or what can I do to know where the problem is?
tnx.
6 replies
RRCRat Rig Community [Unofficial]
•Created by Hydr0s on 8/31/2024 in #fix-my-printer
TMC 'extruder' reports error: GSTAT: 00000001 reset=1(Reset)
I I also keep having this issue an several printers. whit and whit out tool board. 2 vcore 4 500 hybrid and 1 vcore3.1 400
9 replies
RRCRat Rig Community [Unofficial]
•Created by stizler on 11/5/2024 in #ratos-support
No Beacon model loaded
Hi,
I changed it so the sensor lines are above the auto saved data and it's working now.
i calibrated the beacon only whit initial and final beacon calibration and first layers are now consistent.
6 replies