Gizzle
Gizzle
PostsComments
RRCRat Rig Community [Unofficial]
Created by Gizzle on 1/23/2024 in #german-support
ROME Extruder 2 IFCNT Fehler
No description
6 replies
RRCRat Rig Community [Unofficial]
Created by Gizzle on 10/12/2023 in #german-support
Ringing trotz Input Shaper
No description
7 replies
RRCRat Rig Community [Unofficial]
Created by Gizzle on 5/15/2023 in #ratos-support
Unable to overwrite Octopus ADXL config
No description
11 replies
RRCRat Rig Community [Unofficial]
Created by Gizzle on 5/12/2023 in #german-support
ADXL EBB36 Fehler
Tag zusammen, ich bin grad dabei nach dem Update auf RatOS 2.x den ADXL von meinem EBB36 (angeschlossen per CAN) wieder zum laufen zu bekommen, jedoch wirft er mir einen "Invalid ID" Fehler. In der Config habe ich das hier am Ende eingefügt: 
[adxl345 ebb36]
cs_pin: ebb36:adxl345_cs_pin
spi_software_sclk_pin: ebb36: PB10
spi_software_mosi_pin: ebb36: PB11
spi_software_miso_pin: ebb36: PB2

#ADXL345 resonance testing configuration
[resonance_tester]
accel_chip: adxl345 ebb36
probe_points:
    100,100,20 # 200mm printer
    #150,150,20 # 300mm printer
    #200,200,20 # 400mm printer
    #250,250,20 # 500mm printer
[adxl345 ebb36]
cs_pin: ebb36:adxl345_cs_pin
spi_software_sclk_pin: ebb36: PB10
spi_software_mosi_pin: ebb36: PB11
spi_software_miso_pin: ebb36: PB2

#ADXL345 resonance testing configuration
[resonance_tester]
accel_chip: adxl345 ebb36
probe_points:
    100,100,20 # 200mm printer
    #150,150,20 # 300mm printer
    #200,200,20 # 400mm printer
    #250,250,20 # 500mm printer
Jemand eine Idee, was ich noch probieren könnte?
32 replies
RRCRat Rig Community [Unofficial]
Created by Gizzle on 5/8/2023 in #fix-my-print
Wavy Corners
No description
4 replies
RRCRat Rig Community [Unofficial]
Created by Gizzle on 4/28/2023 in #ratos-support
Klipperscreen restart service error
No description
13 replies