Ray
RRCRat Rig Community [Unofficial]
•Created by Ray on 7/3/2024 in #fix-my-mesh
V-core 3.0 500 Mesh
Hey, sorry for the late reply. I did do z-tilt, yes. Homed all > Z-tilt > Home Z > bed mesh. I think that’s the right order to do it?
5 replies
RRCRat Rig Community [Unofficial]
•Created by Ray on 11/23/2023 in #fix-my-print
My nozzle stole my print
Perfect thanks, I’ll give this a go now, I should have a spare nozzle somewhere. Sorry for the late reply and again thank you for all the help
15 replies
RRCRat Rig Community [Unofficial]
•Created by Ray on 11/23/2023 in #fix-my-print
My nozzle stole my print
These are my speeds: https://gyazo.com/ad929f755d5fd821349cbd2909184d8b
they came stock with the profile, maybe i need to tune them down a bit?
15 replies
RRCRat Rig Community [Unofficial]
•Created by Ray on 11/23/2023 in #fix-my-print
My nozzle stole my print
Don’t want to dump too many problems here but I’m also having some issues with my Z axis where when I send the bed down, it makes this horrible almost scratching or like it’s catching on something. It only happens when it’s going down though. I’m guessing it’s just an alignment issue and I need to try and reseat everything. Sorry to dump all of this just want to get my baby back in working order, I appreciate all the help
15 replies
RRCRat Rig Community [Unofficial]
•Created by Ray on 11/23/2023 in #fix-my-print
My nozzle stole my print
I’m assuming it could have something to do with the extrusion multipler so I’ll have to retry a print when I can apart from that I’m not sure what it could be 
15 replies
RRCRat Rig Community [Unofficial]
•Created by Ray on 11/23/2023 in #fix-my-print
My nozzle stole my print
15 replies
RRCRat Rig Community [Unofficial]
•Created by Ray on 11/23/2023 in #fix-my-print
My nozzle stole my print
Thanks both, i'll give this a try and see what happens. My PETG is kinda old but i'm not hearing any popping when it's printing, but i could try drying it to see if it will help. I followed the klipper guide for doing flow (i think it was anyway?) and the rotation_distance stuff and that seemed fine to me, is there anything else i need to look at flow/extrusion wise? Thanks again :)
15 replies