V-core 3.0 500 Mesh
Hi, i've tried to fix my bed mesh but have had no luck so far. I've tried adjusting my frame to see if that helps but it doesn't seem to be doing it, so maybe i'm doing something wrong. Any help would be appreciated. I can give anymore info if needed, thanks!
3 Replies
It’s hard to tell from the picture but did you run z-tilt before you did the mesh? Klipper does not do that automatically as some printers do not support automatic bed leveling. .
Hey, sorry for the late reply. I did do z-tilt, yes. Homed all > Z-tilt > Home Z > bed mesh. I think that’s the right order to do it?
Home all and then z-tilt and then bed mesh. home z will be taken care of during homing. Though it should not cause any issues. Somethings seems off as if you had a good z-tilt these three points should all be level and they are not. Can you try again and just home -> z-tilt and then height map? Also is the bed hot or cold?
