Qwuille
RRCRat Rig Community [Unofficial]
•Created by Qwuille on 2/6/2025 in #ratos-support
RatOS eth0 issues.
Hello.
I am having this issue where the raspberry pi does not want to communicate with my dhcp for a dynamic ip address.
When setting it static address i can access the gateway which is on another ip than the dhcp, but i can still not reach the dhcp server nor can i reach my network.
Had IT support trying to figure out the issue, but they can also not answer anything so far.
The machines are in a facility along other printers at a corporation, used in the print farm. So the network infrastructure is huge and managed.
All other raspberry pies with RaspOS, 3DPrinterOS is working as they are supposed to via ethernet, the only release of *nix that will not play ball is RatOS.
Is there a way to revert back to "stock" RaspOS network logic?
Wifi is out of the question.
Running RatOS 2.1 image from github on a raspberry pi 3b+. Machine is two RatRig Vcore 3.1
6 replies
RRCRat Rig Community [Unofficial]
•Created by Qwuille on 5/20/2024 in #fix-my-printer
Klicky Probe not attaching after first print.
I have a cleanly installed RatRig Vcore3.1 500 with Enclosure v2.
When testing the probe with the attach and detach macros, everything works fine.
When i start a print it also works flawlessly, but when i try to print anything later on without restarting klipper, the print head gows half speed and tries to pickup the probe as if it was a 400x400 area.
After restarting Klipper, everything is fine again until i want to print afterwards.
2 replies