thegribbs Comments - Answer Overflow

thegribbs

Posts Comments

RRCRat Rig Community [Unofficial]

•Created by thegribbs on 2/27/2024 in #ratos-support

PAM Invalid

pam still says invalid, but maybe because the repository has been taken down

7 replies

RRCRat Rig Community [Unofficial]

•Created by thegribbs on 2/27/2024 in #ratos-support

PAM Invalid

[pam] [gcode_macro _START_PRINT_BED_MESH] gcode: {% if printer["gcode_macro RatOS"].calibrate_bed_mesh|lower == 'true' %} PAM PROFILE=ratos {% endif %} BED_MESH_PROFILE LOAD=ratos

7 replies

RRCRat Rig Community [Unofficial]

•Created by thegribbs on 2/27/2024 in #ratos-support

PAM Invalid

I've got it working by removing anything I had relating to PAM in printer.cfg and pasting the following

7 replies

RRCRat Rig Community [Unofficial]

•Created by thegribbs on 2/27/2024 in #ratos-support

PAM Invalid

Also, I'm not sure why Mainsail is now unknown

7 replies

RRCRat Rig Community [Unofficial]

•Created by thegribbs on 2/21/2024 in #ratos-support

LDO ADXL with RatOS v1.1

Thanks, that worked!

14 replies

RRCRat Rig Community [Unofficial]

•Created by thegribbs on 2/21/2024 in #ratos-support

LDO ADXL with RatOS v1.1

Yeah. For now, I was really hoping not to have to upgrade to v2. do you happen to remember anybody doing this before the v2 release. I don't need to integrate macros or anything. I'm happy to just get some resonance files

14 replies

RRCRat Rig Community [Unofficial]

•Created by thegribbs on 2/21/2024 in #ratos-support

LDO ADXL with RatOS v1.1

"and in that case a config for the ADXL345 connected to the Raspberry Pi is also available."

14 replies

RRCRat Rig Community [Unofficial]

•Created by thegribbs on 2/21/2024 in #ratos-support

LDO ADXL with RatOS v1.1