Primeline different in RatOS 2.0 than in 1.x
Hello Guys. Can someone Tell me how i get the old Position of the Primeline from RatOS 1.x back?
In RatOS 2.0 the Prime Line is on the opposite Site (right) now. And the gantry slams a little Bit to hard into the Front right Pully Plate.
I own a V-core 3 400
7 Replies
Maybe you should chek you XY offsets. Maybe you Y endstop should be moved back a bit, recheck and recheck. Then adjust your printer.cfg if you really can't make the hardware match the standard setup.
this is the correct answer
Your printer should not be able to crash into anything, that means your physical endstop positions (and possible position_min/position_max/position_endstop) are wrong.
Thx Boss ☺️
And by the way, the new homing sequence is much better for the wire loom, IMHO
stormy-goldOP•2y ago
Thank you Guys. Problem solved. I Had to pull Back the endstop Block a little Bit.
I've set z offset and my bed slams into the nozzle at the start of the primeline...this is after successfully completing homing, z-tilt and mesh
please start your own new post
front