PAM Invalid
After a hard reset of the power to my printer, PAM is invalid. I understand that PAM is depreciated and replaced by Adaptive Meshing, but I'm not in a position to upgrade to RatOS 2 at the moment.
Is there a way to get PAM working again until I have time to make upgrades to RatOS 2?
3 Replies
Also, I'm not sure why Mainsail is now unknown
Hard power reset might have corrupted the SD card
I've got it working by removing anything I had relating to PAM in printer.cfg and pasting the following
[pam]
[gcode_macro _START_PRINT_BED_MESH]
gcode:
{% if printer["gcode_macro RatOS"].calibrate_bed_mesh|lower == 'true' %}
PAM PROFILE=ratos
{% endif %}
BED_MESH_PROFILE LOAD=ratos
pam still says invalid, but maybe because the repository has been taken down