Kuba Šinták
RRCRat Rig Community [Unofficial]
•Created by Kuba Šinták on 4/6/2024 in #ratos-support
klipper reports startup
Hi there, I have updated my printer and since than, I cannot get past then blue anouncement that the klipper is in startup, try later. Sometimes it says cannot connect to MCU. I have restarted the printer and control board several time. I am running RPI and SKR V1.2, I might have accicentally pressed the reset button on it. Anyone experienced something similar? Any help is appreciated
51 replies
RRCRat Rig Community [Unofficial]
•Created by Kuba Šinták on 1/5/2023 in #fix-my-mesh
Nozzle too low all the time
I have encountered a rather weird problem. The nozzle is ALWAYS too low. I have run several probe calibrations (I have BL touch) and mesh calibrations, both seem fine.
When I run print, the nozzle is 0,7 lower than it should be and when I dont lift it, it scrapes the bed hard.
Any suggestion what to do with this?
10 replies