Johetan
RRCRat Rig Community [Unofficial]
•Created by Johetan on 2/15/2025 in #fix-my-printer
Controller fan bogus.
Do you guys know how I can find out if my controller fan mosfet is dead?
The fan always spins at idle, no matter what I do.
Controlling it via enable and pwm or not doesn't change anything. Only the green led lights up.
A few minutes ago it worked, but suddenly stopped working again.
11 replies
RRCRat Rig Community [Unofficial]
•Created by Johetan on 1/6/2025 in #fix-my-print
Underextrusion with different nozzles
I have severe underextrusion using different nozzles.
Using 0.5mm cht nozzle.
Extrusion distance checks out.
Using orbiter 2.0.
Extruding filament gives me a 0.5 dia.
Applying a 130mm Extrusion factor gives me wonderful results.
7 replies
RRCRat Rig Community [Unofficial]
•Created by Johetan on 1/5/2025 in #ratos-support
Temperature Wait unexpected behavior
Wir start print I get this message.
My Ratos macro does contain the variable.
variable_preheat_extruder_temp: 185
RatOS | TEMPERATURE_WAIT: Waiting for sensor: extruder, MINIMUM: 0, MAXIMUM: 5
What am I missing?
15 replies