Lascoose
RRCRat Rig Community [Unofficial]
•Created by Lascoose on 1/2/2024 in #fix-my-printer
V minion heater bed on the fritz
Howdy everyone, my heaterbed out of no where started giving me issues, and updating all the firmware didn't work either. It takes roughly 5 full reboots to get the thermistor to register the temperature. I'm assuming the thermistor probe is just dying, but at the same time it doesn't fail once it starts working for a print. Anyone have a similar issue in the past? And if it is the probe dying, how much of a pain and $ and I looking at to fix it?
6 replies
RRCRat Rig Community [Unofficial]
•Created by Lascoose on 6/10/2023 in #ratos-support
Need help pausing print at layer for magnet drop.
I've never had to do a print pause in gcode for all the time I've been printing. I can see that variable_pause_print_park_in is a thing in the macros, specifically moving the toolhead to the "back". What would be an example gcode for pausing a print at 1.4mm height, toolhead back of printer? Using a V-minion.
5 replies
RRCRat Rig Community [Unofficial]
•Created by Lascoose on 2/18/2023 in #ratos-support
/dev/btt-manta-m4p no such file or directory
65 replies
RRCRat Rig Community [Unofficial]
•Created by Lascoose on 2/18/2023 in #ratos-support
m4p + cb1 RatOs 2.0xx
I saw the other support post about the cb1 in general, but seeing the m4p works with the V2 software I thought I'd give it a go. I tried just loading up the SD card and change the wifi credentials but no avail (yes I saw after the fact there is no CB1 directory included to make life easy.).
Is this guide still the best way + the jank work arounds discussed here?
(https://3dpandme.com/2022/10/02/tutorial-btt-manta-m8p-cb1-ratos-install-guide/)
27 replies