m4p + cb1 RatOs 2.0xx
I saw the other support post about the cb1 in general, but seeing the m4p works with the V2 software I thought I'd give it a go. I tried just loading up the SD card and change the wifi credentials but no avail (yes I saw after the fact there is no CB1 directory included to make life easy.).
Is this guide still the best way + the jank work arounds discussed here?
(https://3dpandme.com/2022/10/02/tutorial-btt-manta-m8p-cb1-ratos-install-guide/)
dmason
3DP and Me
Tutorial: BTT Manta M8P + CB1 RatOS install guide
UPDATE: RatOS now now supports the manta and CB1 boards as of beta v2.0. I am leaving the guide below for reference but it is strongly advised to simply use the official RatOS route. Note changes sā¦
17 Replies
Yes, use the image that Mikel built. I am not sure if he merged in the changes needed to set the wifi credentials, but otherwise it should be exactly the same as regular beta image
https://github.com/Rat-OS/RatOS/suites/10986151873/artifacts/556842954
I just checked and he did merge in the changes to the configurator, so you just need to make sure to update the configurator before you do the configuration steps
@davefrom3dpandme might want to update your post to point to the official CB1 Rat-OS image
@lascoose plus the 2.x version of Rat-OS supports the manta (both versions) so it is just an include file line in your printer.cfg
wise-whiteā¢3y ago
Yup good point! I did the m8p but forgot about the m4p
Mm the warning is right there at the top of the blog š
I am decently confused. I have found the post and downloaded / opened the zip. Is this like a vscode situation where I have to create an image from the download or reference it in putty to download?
or am I taking the v2.0.0 beta, slapping that image onto the sd, then throwing over a file into it so it can talk to the CB1
No, take the v2 beta link I posted, burn to SD. THE END
that link sends me to a 404 error.
You need to be signed in to GitHub to download it
thank you. Apologies I'm more hardware than software
@miklschmidt can you move over the image from GitHub actions to the releases section.so it's easier for people to download?
No worries! I put in a lot of work to get the cb1 supported so I am just glad to see people besides me use it
Yessir, gimme a sec
downloading now, tysm I appreciate the effort you put in to expand our hardware options. especially in the 3 year pi shortage we're in
Yup, I didn't feel like paying scalper price for raspberry pi either
gaah uploading takes forever
Will let you know when it's ready
Too bad the GitHub actions can't move it automatically
It can, but i only have it setup as a release script
Next time i make a release it'll show up automatically
Ohh nice!
https://github.com/Rat-OS/RatOS/releases/tag/v2.0.0-beta2 @here done! š
Just wanted to follow up, successfully installed and going through the updates rn. thanks again