im too uncreative
RRCRat Rig Community [Unofficial]
•Created by im too uncreative on 8/18/2024 in #ratos-support
Beacon + RatOS 2.1 / VC3.1 400mm - "Unknown config object 'beacon'"
Thanks, I must have messed up in the configurator stage. Your help is much appreciated my friend!
19 replies
RRCRat Rig Community [Unofficial]
•Created by im too uncreative on 8/18/2024 in #ratos-support
Beacon + RatOS 2.1 / VC3.1 400mm - "Unknown config object 'beacon'"
The error log is a text file, I didn't know how else to export it sorry
19 replies
RRCRat Rig Community [Unofficial]
•Created by im too uncreative on 8/18/2024 in #ratos-support
Beacon + RatOS 2.1 / VC3.1 400mm - "Unknown config object 'beacon'"
Sure, give me a few mins
19 replies
RRCRat Rig Community [Unofficial]
•Created by im too uncreative on 8/18/2024 in #ratos-support
Beacon + RatOS 2.1 / VC3.1 400mm - "Unknown config object 'beacon'"
Hmm still getting the same issue 😟 . I was veeeery careful installing it, so I don't see how I could have damaged it.
19 replies
RRCRat Rig Community [Unofficial]
•Created by im too uncreative on 8/18/2024 in #ratos-support
Beacon + RatOS 2.1 / VC3.1 400mm - "Unknown config object 'beacon'"
19 replies
RRCRat Rig Community [Unofficial]
•Created by im too uncreative on 11/24/2023 in #fix-my-print
Large gaps in first layer, unsure what to try next (V-Core 3.1 400mm)
Hey just to update, I figured out SuperSlicer adds pressure advance into the g-code, but I still can't find it within the settings. I just edited it to be 0 in the g-code.
You were absolutely right about the offset, I was hesitant to go any lower with my offset as I was already getting about 0.2mm first layer height, and I was terrified of the nozzle crashing into the bed.
In the end I decreased it about 0.04mm and my first layers are looking much better!
Thanks for your suggestion 🙂
8 replies
RRCRat Rig Community [Unofficial]
•Created by im too uncreative on 11/24/2023 in #fix-my-print
Large gaps in first layer, unsure what to try next (V-Core 3.1 400mm)
8 replies
RRCRat Rig Community [Unofficial]
•Created by im too uncreative on 11/24/2023 in #fix-my-print
Large gaps in first layer, unsure what to try next (V-Core 3.1 400mm)
Hi there,
I have noticed small pinholes around the perimeter like you describe throughout all my prints, as seen in the attached image.
I tried one test, decreasing z-offset by 0.025, although I believe this was too close to the bed. I think that I have it calibrated correctly now, although I will now play around with it.
Do you know how I can disable pressure advance in SuperSlicer? Thanks.
8 replies