Ravem0n
RRCRat Rig Community [Unofficial]
•Created by Ravem0n on 11/12/2023 in #fix-my-mesh
Odd Bed Mesh
I am using an euclid probe, it does have a bit of flex, but only until recently it started happening
4 replies
RRCRat Rig Community [Unofficial]
•Created by Ravem0n on 11/12/2023 in #fix-my-mesh
Odd Bed Mesh
I have retighten the screws and ensured the toolhead has minimal play. still having that same weird mesh
4 replies
RRCRat Rig Community [Unofficial]
•Created by Ravem0n on 8/30/2023 in #fix-my-printer
Euclid probing issue (new install)
Found the issue. Horizontal_move_z was set lower than the z offset. Really weird how I was able to do a bed mesh normally. Then it throws the error after the bed mesh is done
6 replies
RRCRat Rig Community [Unofficial]
•Created by Ravem0n on 8/30/2023 in #fix-my-printer
Euclid probing issue (new install)
Z-hop is default. I haven’t changed anything, but this is during probing before the actual print starts so I’m not sure how it’s related. All the other probing is fine.
6 replies
RRCRat Rig Community [Unofficial]
•Created by Ravem0n on 8/30/2023 in #fix-my-printer
Euclid probing issue (new install)
It hits the print surfac
6 replies