Odd Bed Mesh
I've just noticed my mesh has been doing this recently, I am not sure what happened since i haven't really changed anything. I checked under the plate to make sure nothing was under there in that area. Not sure what else to check
2 Replies
Is the umbilical pushing against something when the print head is on the right side? If your toolhead isn't tightly enough attached, that might influence the height between the toolhead and the bed
wee-brownOP•13mo ago
I have retighten the screws and ensured the toolhead has minimal play. still having that same weird mesh
I am using an euclid probe, it does have a bit of flex, but only until recently it started happening