Covert
Covert
RRCRat Rig Community [Unofficial]
Created by Covert on 4/2/2025 in #ratos-support
Expansion ports pins not being copied to RatOS.cfg using wizard (EXP1_1 etc)
In the wizard I selected btt-octopus-11. It has pin aliases defined for the Expansion ports but they where not copied by the wizard to RatOS.cfg. I had to manual add them to get Expansion ports working for my LCD screen.
2 replies
RRCRat Rig Community [Unofficial]
Created by Covert on 4/2/2025 in #ratos-support
expected probe state to be deployed but is stowed (1) on start of print
Just added the klicky to my RR 3.1 500 and the klicky does everything fine. Z home, z tikt, bed mesh, stow and deploy. When I print I get the above error after the inital home and heating before print, extruder moves to do the pre print blob and the error comes. The probe is infact attached as this point. I would of expected it to detect before it does the blob and I think that is the error
7 replies
RRCRat Rig Community [Unofficial]
Created by Covert on 5/6/2024 in #fix-my-printer
VC3.1 Orbiter Extruder Skipping
Removed PTFE tube to eliminate that. Removed and cleaned the nozzle a number of times. Not sure what to check next.
2 replies
RRCRat Rig Community [Unofficial]
Created by Covert on 5/6/2023 in #fix-my-printer
Clogged hotend?
No description
3 replies
RRCRat Rig Community [Unofficial]
Created by Covert on 5/2/2023 in #ratos-support
Connect to local Wifi Network?
I configured my Pi3 over Lan and now I want it to connect to my local wifi network. Is there a menu to set up the wifi to my local SSID ?
2 replies