WhisperedSolace
RRCRat Rig Community [Unofficial]
•Created by WhisperedSolace on 3/19/2025 in #ratos-support
Unable to read tmc uart 'dual_carriage' register IFCNT
Ive tripple checked wiring, pins, and the uart jumpers, ive reinstalled software, ive put a new Octo board in, new drivers(2209), anytime i try "SET_CENTER_KINEMATIC_POSITION" and move the dual carriage, i get the error everytime, i move bed up and down no issues, but as soon as i touch the heads, it faults and reboots.
2 replies
RRCRat Rig Community [Unofficial]
•Created by WhisperedSolace on 3/16/2025 in #fix-my-printer
Klipper shutdown
Please help, I've gone through every wire to the bigtree and triple checked the documents. Anytime i try to move the Carriage for a Idex setup, 10 mm left or right, i get this fault "Unable to read tmc uart 'dual_carriage' register IFCNT" It then goes into a klipper shutdown
8 replies