F1sH
RRCRat Rig Community [Unofficial]
•Created by F1sH on 7/2/2024 in #fix-my-printer
Octopus v1.1 not sending signal to heated bed *fresh RatOS instal*
Happy 4th 🙂
18 replies
RRCRat Rig Community [Unofficial]
•Created by F1sH on 7/2/2024 in #fix-my-printer
Octopus v1.1 not sending signal to heated bed *fresh RatOS instal*
I got my hands on some nice 3m fuses and everything works as it should. I spent far too much time looking over my wiring and checking other components ><
18 replies
RRCRat Rig Community [Unofficial]
•Created by F1sH on 7/2/2024 in #fix-my-printer
Octopus v1.1 not sending signal to heated bed *fresh RatOS instal*
I'll give this a try thank you!
18 replies
RRCRat Rig Community [Unofficial]
•Created by F1sH on 7/2/2024 in #fix-my-printer
Octopus v1.1 not sending signal to heated bed *fresh RatOS instal*
One of the fuses did fail a continuity test on my multimeter. The one closest to the black screw terminals. I replaced it with the unused fuses from my second board. I still am not seeing voltage from the bed out.
18 replies
RRCRat Rig Community [Unofficial]
•Created by F1sH on 7/2/2024 in #fix-my-printer
Octopus v1.1 not sending signal to heated bed *fresh RatOS instal*
I do have power 24v dc going into the board but nothing coming out. Do you know what amp the fuses are by chance? My wife works at an industrial supply store and I can have her grab some spares.
18 replies
RRCRat Rig Community [Unofficial]
•Created by F1sH on 7/2/2024 in #fix-my-printer
Octopus v1.1 not sending signal to heated bed *fresh RatOS instal*
Both the boards that I have have are 446 chips, I'll have to double check to make sure I used the correct config. I didnt think of that.
18 replies
RRCRat Rig Community [Unofficial]
•Created by F1sH on 7/2/2024 in #fix-my-printer
Octopus v1.1 not sending signal to heated bed *fresh RatOS instal*
18 replies
RRCRat Rig Community [Unofficial]
•Created by F1sH on 7/2/2024 in #fix-my-printer
Octopus v1.1 not sending signal to heated bed *fresh RatOS instal*
I plan on waiting for 2.1 to get the kinks worked out of it before I make the jump. I have the PSU wired to the bed in and bed out wired to the DC side of the SSR. I did updated everything after install.
18 replies
RRCRat Rig Community [Unofficial]
•Created by F1sH on 4/26/2024 in #ratos-support
Beacon Probe revH Input shaper
Well now that I finally admitted defeat I found this, it seems to have worked:
[resonance_tester]
accel_chip: beacon
probe_points: 90, 90, 20
4 replies