creston
RRCRat Rig Community [Unofficial]
•Created by creston on 6/1/2024 in #ratos-support
Kilpper Resonance_generator
thinking something similar to the skew correction
19 replies
RRCRat Rig Community [Unofficial]
•Created by creston on 6/1/2024 in #ratos-support
Kilpper Resonance_generator
Side question, typically I print with ASA on my 500mm, is there a way to compensate for the shrinkage in the RatOS?
19 replies
RRCRat Rig Community [Unofficial]
•Created by creston on 6/1/2024 in #ratos-support
Kilpper Resonance_generator
Thank you for sending the commands, I took the harder route and cleared off the sdcard and made a new RatOS image, got everything updated and calibrated again.
19 replies
RRCRat Rig Community [Unofficial]
•Created by creston on 6/1/2024 in #ratos-support
Kilpper Resonance_generator
what would you say is the best plan of action here, start fresh?
19 replies
RRCRat Rig Community [Unofficial]
•Created by creston on 6/1/2024 in #ratos-support
Kilpper Resonance_generator
pretty sure i did the hard recovery
19 replies
RRCRat Rig Community [Unofficial]
•Created by creston on 6/1/2024 in #ratos-support
Kilpper Resonance_generator
Ive been reading a few of the comments on here, sounds like it has been a bit of a headache.
19 replies
RRCRat Rig Community [Unofficial]
•Created by creston on 6/1/2024 in #ratos-support
Kilpper Resonance_generator
I updated everything, RatOS said corrupt so i followed the prompts to update, I assume that is the hard recovery you are mentioning.
19 replies
RRCRat Rig Community [Unofficial]
•Created by creston on 6/1/2024 in #ratos-support
Kilpper Resonance_generator
@miklschmidt
19 replies
RRCRat Rig Community [Unofficial]
•Created by creston on 6/1/2024 in #ratos-support
Kilpper Resonance_generator
19 replies