creston
RRCRat Rig Community [Unofficial]
•Created by creston on 2/16/2025 in #fix-my-print
Solid bottom layers gradually over extrude
I am assuming the bottom layers are over extruding but I am not sure. I use Polymaker ASA for the majority of my prints, and I can get pretty good prints out of my 3.1 500. It seems once I try to print something with a larger footprint the bottom layers start to smoosh for every extra layer even if I have the first layer higher than would be normal in anticipation of the over extrusion of the following solid layers. I have my extrusion multiplier set to 0.925 which has been resulting a pretty smooth top layer even with 8 top layers. Has anyone ran into an issue like this? I'll post a photo once the latest print is complete.
2 replies
RRCRat Rig Community [Unofficial]
•Created by creston on 6/1/2024 in #ratos-support
Kilpper Resonance_generator
Hey all, i just updated klipper and now im getting a, Section 'resonance_generator' is not a valid config section. Any help would be appreciated. Thanks
19 replies