Kamil
RRCRat Rig Community [Unofficial]
•Created by SithMaster015 on 11/5/2024 in #fix-my-print
PETG Problems
Could you share you seetings anyway? I have bad prints with PETG. After drying it works better but bridges especially are very bad at any temperature.
10 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/11/2024 in #fix-my-resonance
shaper graph low y acceleration V Core 500
I got on my v400 6600
16 replies
RRCRat Rig Community [Unofficial]
•Created by solmaelstrom on 7/11/2024 in #fix-my-resonance
shaper graph low y acceleration V Core 500
Try to increase the belt both belt tension above 4e6
16 replies
RRCRat Rig Community [Unofficial]
•Created by hhes on 7/9/2024 in #fix-my-print
[VC4 400] Pattern on the wall
check as well if your z axis don't play
16 replies
RRCRat Rig Community [Unofficial]
•Created by hhes on 7/9/2024 in #fix-my-print
[VC4 400] Pattern on the wall
one of them...guess worth to try?
16 replies
RRCRat Rig Community [Unofficial]
•Created by hhes on 7/9/2024 in #fix-my-print
[VC4 400] Pattern on the wall
Did you played with orbiter tensioner?
16 replies
RRCRat Rig Community [Unofficial]
•Created by hhes on 7/9/2024 in #fix-my-print
[VC4 400] Pattern on the wall
Have you tried different filament? jus a stupid question...Which temperature you put? I use for pla 220C so far so good.
16 replies
RRCRat Rig Community [Unofficial]
•Created by hhes on 7/9/2024 in #fix-my-print
[VC4 400] Pattern on the wall
How is your set of the pressure advance? For me works good 0.025 and smooth 0.03 from orbiter website. Second check if the browden tubes are not causeing too much friction.
16 replies