marcin1415.
RRCRat Rig Community [Unofficial]
•Created by Mr. Hye on 4/28/2024 in #fix-my-print
Rough artifacts on surface
Do you check y motor? Motor connection, stepstick, grubscrew on motor pulley?
61 replies
RRCRat Rig Community [Unofficial]
•Created by Mr. Hye on 4/28/2024 in #fix-my-print
Rough artifacts on surface
Do you check filament tension screw? Incrase tenshion 1-2 full rotation and test print.
61 replies
RRCRat Rig Community [Unofficial]
•Created by Mr. Hye on 4/28/2024 in #fix-my-print
Rough artifacts on surface
Looks like extruder problem. Check extruder gears clean and noozle clog.
61 replies
RRCRat Rig Community [Unofficial]
•Created by Bizilux on 4/8/2024 in #fix-my-printer
layer shift on newly assembled printer
Looks like your belts its tight very weak. Could make situation at high speed that belt skipping on motor pulley touth. Tighten belts correctly and reprint test.
6 replies
RRCRat Rig Community [Unofficial]
•Created by Brandon on 4/7/2024 in #fix-my-print
is this underextruding?
Maybe noozle partial cloged? Check extruder motor vref - too low too much . Check extruder tension screw. Add more tension.
14 replies
RRCRat Rig Community [Unofficial]
•Created by Brandon on 4/7/2024 in #fix-my-print
is this underextruding?
Do you checking extruder? Clean extruder gears, center rotation gears?
14 replies