AlexB-Cat
AlexB-Cat
RRCRat Rig Community [Unofficial]
Created by AlexB-Cat on 1/28/2023 in #fix-my-print
Superslicer general config help...
No description
10 replies
RRCRat Rig Community [Unofficial]
Created by AlexB-Cat on 1/26/2023 in #fix-my-printer
Help with BTT Smart Filament Sensor config V-Minion
Ok, just installed the BTT SFS but have some doubts if in the printer.cfg file under macros ratos the following would be right, I'm a nerd at this and want it to be safe in case I ran out of filament, so anyone with experience could check if G-code instructions is right? Thanks I'll be using the following: [filament_motion_sensor SmartFilamentSensor] detection_length: 7.0 extruder: extruder switch_pin: ^PE15 pause_on_runout: True runout_gcode: SAVE_GCODE_STATE NAME=PAUSE_state BASE_PAUSE G91 G1 E-5 F2100 G1 Z10 G90 G1 X90 Y175 F6000 #insert_gcode: event_delay: 3 pause_delay: 0.5
31 replies
RRCRat Rig Community [Unofficial]
Created by AlexB-Cat on 1/3/2023 in #fix-my-printer
(SOLVED) V-Minion error “Print exceeds max extrusion”
No description
8 replies
RRCRat Rig Community [Unofficial]
Created by AlexB-Cat on 12/23/2022 in #fix-my-printer
(SOLVED)SKR PRO 1.2 + BLTOUCH not working
Hi again, I'm trying to make BlTouch to work on my V-Minion under SKR Pro 1.2 board, X and Y work fine, but BlTouch is not starting properly, been reading through Klipper's docs and it seems that I might have to define some pins on printer.cfg file, I don't know how to and don't want to hit my bed again like last night...might have partially bended bltouch sensor...not sure. I'm stuck here... https://www.klipper3d.org/BLTouch.html#initial-tests Thanks everyone for your help !!!
5 replies
RRCRat Rig Community [Unofficial]
Created by AlexB-Cat on 12/17/2022 in #fix-my-printer
(SOLVED)Rasp Pi 3b+ not detecting ratos.local host ???
I loaded everything on Pi's card and did the first config and detected ratos.local fine...now I finished wiring everything to BTT SKR Pro 1.2 motherboard and when I start it again to upload firmware to MB I can't access local host anymore, BL-Touch does funny things when I turn on the printer....any ideas of what I'm doing wrong? Thanks
30 replies