captnexcitement
captnexcitement
RRCRat Rig Community [Unofficial]
Created by Andy on 4/21/2024 in #ratos-support
Error message
In regards to the CONFIG entry for Input Shaper, now that max_accell_to_decel has been changed to minimum_cruise_ratio, do you simply remove that from the user overrides? Do I need to replace that line with a minimum_cruise_ratio value? If i do need to add a minimum_cruise_ratio value ho do I determine a good value to use? I that something you pull from the graphs? My apologies if this is well documented somewhere, I've been searching the documents and internet and have yet to find an answer.
4 replies
RRCRat Rig Community [Unofficial]
Created by Synapsis on 6/17/2023 in #ratos-support
fatal: detected dubious ownership
I had this same issue, after step seven I rebooted the pi. I then continued from step eight and got the fatal error, the fix for me was that I did not cd back into crowsnest. Once I got back into that directory everything worked.
21 replies
RRCRat Rig Community [Unofficial]
Created by captnexcitement on 3/30/2024 in #fix-my-printer
V-Core 3.1 commissioning
No description
13 replies
RRCRat Rig Community [Unofficial]
Created by captnexcitement on 3/30/2024 in #fix-my-printer
V-Core 3.1 commissioning
Appreciate the feedback.
13 replies
RRCRat Rig Community [Unofficial]
Created by captnexcitement on 3/30/2024 in #fix-my-printer
V-Core 3.1 commissioning
Ok looks like the fan settings in the PSlicer is the issue. MIN and MAX was defaulted to 100/100, fairly confident I will get this sorted but that will have to wait until Monday.
13 replies
RRCRat Rig Community [Unofficial]
Created by captnexcitement on 3/30/2024 in #fix-my-printer
V-Core 3.1 commissioning
Will do, this is my first Klipper machine, I have a PRUSA but this definitely a steep learning curve. I’m thinking the 4028 server fan is overkill for my setup considering its cooling capabilities overpowers the hot end. Would it be better to run a smaller fan or is it better to run the 4028 and a lower load?
13 replies
RRCRat Rig Community [Unofficial]
Created by captnexcitement on 3/30/2024 in #fix-my-printer
V-Core 3.1 commissioning
I will look into it and revert back, thanks!
13 replies
RRCRat Rig Community [Unofficial]
Created by captnexcitement on 3/30/2024 in #fix-my-printer
V-Core 3.1 commissioning
Not sure I did not look for a fan setting in PSLICER.
13 replies
RRCRat Rig Community [Unofficial]
Created by captnexcitement on 3/30/2024 in #fix-my-printer
V-Core 3.1 commissioning
I just did, I got the fan back on, it was a bad wire. I also sorted out the 0-100 issue. Now the parts cooling fan kicks on during a print at 100% and cools down the hot end causing kipper to shut down. The hot end heater cannot overcome the cooling from the parts cooling fan.
13 replies