vc3.1 400 impossible to align both peaks
I'm trying to maximise the quality of my v-core but i can't find a solution to make the yellow line as high and synced with the blue one.
Need advices please
12 Replies
here are the shaper graphs
are you measuring with EBB42? Make sure its fastned OK and all wires are tucked in nicely.. It feels like the EBB is loose.. or you have massive issues 🙂
no i'm using the beacon as since i installed the 2.1 ratos my adxl is not recognised ( it was working before the update on ratos 2.1 though )
don't measure with beacon. You don't have a toolboard?
Nope, i have the adxl tighly fixed but if i do « accelerometer_query » i got response but when i use the macro to get graphs it says invalid id got 0 vs e5
Then begin to check that the beacon is securely mounted and that the USB cable is fixed
Yes it is, all the way long to the board following the ptfe
Beacon is not mounted in a place to get good measurements for resonance. You need to use a toolhead board or an adxl.
Sorry but do poeple read before answering ?
Thanks for trying to help but i think you missed the part where i say the adxl is not working with the 2.1 ratos and i dont know why
@Helge Keck any idea sir ?
If you get 0 vs e5, your wiring is not good.
But like everyone suggests here, get a toolboard.
Thanks but the toolboard will have to wait a Little 🤗
I have been told that some pictures of the toolhead will help a lot.
Here it is
