The V core500's cable to the extruder hangs down . Any ideas?

V core 500's cable from MCU to Head hangs down.
how are you all solving it?
I'm hanging it from the ceiling now, but this method is not possible at enclosure 2.0.

Nebulator•4/14/23, 6:03 AM

I read a piano wire should do the trick. They come cheap as well, and they come up to 1.2mm thick.

beejayf•4/14/23, 11:05 AM

I wanted to use a 1.5mm glas fiber rod inside a PTFE tube for this but I failed to find a source for now.

primary-violetOP•4/14/23, 11:37 AM

I will try it with 2mm aluminum wire

beejayf•4/14/23, 6:07 PM

I world not recommend aluminum because its structure deteriorates rapidly when bent frequently

primary-violetOP•4/17/23, 2:39 AM

OK I will try it 1.6mm steel wire

NNebulator I read a piano wire should do the trick. They come cheap as well, and they come ...

3DBoomer•4/18/23, 8:37 AM

It does, go for it. 1.2 enough.

3DBoomer•4/18/23, 8:37 AM

piano wire

lillian•4/20/23, 2:07 PM

i use a piece of optical fiber that i secured on both end to the head and the printer and tucked it with the cable in their loom. as its strength come from Kevlar reinforcement it will never brake and is quite bendy