hedj
RRCRat Rig Community [Unofficial]
•Created by hedj on 9/22/2024 in #fix-my-printer
ebb36 1.2 heater always on
My printer was disassembled for a long time. On reassembly I note that on poweron the hotend heater activates. By the time the pi has booted klipper shurs everythinf down at a hotend temperature of about 340C. The smoke suggests that is a real temperature too.
It used not do this. Any ideas?
8 replies
RRCRat Rig Community [Unofficial]
•Created by hedj on 5/7/2023 in #fix-my-print
Terrible infill
5 replies
RRCRat Rig Community [Unofficial]
•Created by hedj on 3/19/2023 in #fix-my-printer
X and Y endstops permanently triggered
3 replies