vimja
RRCRat Rig Community [Unofficial]
•Created by vimja on 3/29/2025 in #fix-my-print
v-core 4 dragging nozzle through print
Now this is a bit embarrassing... but it turns out the problem was that I had the wrong size of nozzle configured. I had 0.6 installed but 0.4 configured. Changing this fixed the issues. Unsurprisingly.
13 replies
RRCRat Rig Community [Unofficial]
•Created by vimja on 3/29/2025 in #fix-my-print
v-core 4 dragging nozzle through print
Found it in the RatOS.cfg. Says it's orbiter 2 extruders. I think that should be correct. I remember reading something like that on the packaging and googling Orbiter 2, that looks like what I have...
13 replies
RRCRat Rig Community [Unofficial]
•Created by vimja on 3/29/2025 in #fix-my-print
v-core 4 dragging nozzle through print
Setting extrusion factor to 80% did indeed improve things. Could an explanation be that I selected the wrong extruder in the set-up wizzard? How can I check what I selected after the fact? And what might be the correct choice? I got the pre-configured set.
13 replies
RRCRat Rig Community [Unofficial]
•Created by vimja on 3/29/2025 in #fix-my-print
v-core 4 dragging nozzle through print
Someone at the local hackerspaces suggested that, too. The first layer looks just fine though.
13 replies